R.V.R. Elettronica PTX30 UHT/S3, Руководство пользователя

Страница: 15 / 122

PTX30 UHT /S3
9 / 36 User Manual Rev. 5.0 - 10/12/2001
5. Quick Start
This chapter gives a concise view of the points that are necessary for the installation
of the device. If any item is not completely clear, for example when you use the
exciter for the first time, we strongly suggest to read throughly the manual.
5.1 Preparation
Unpack the transmitter and before any other operation check the unit for any
shipping damage and check that all the controls and connectors on the front and
rear panels are in good conditions.
Check the mains voltage selector on the rear panel: the selected value is indicated
by an arrow. If required, extract the selector block levering with a little screwdriver
(Fig. 5.1). Rotate the block until the correct printed value corresponds with the
arrow, then reinsert it.
Figura 5.1
If it has been necessary to change voltage, check the fuse value. The required
values are the following:
PTX30 UHT /S3 220-240 Volt - 3,16 A
110-120 Volt - 4,00 A
Now, with a small screwdriver, check that the potentiometer "PWR ADJUST" is
rotated completely counter clockwise (N.B. The pot has ten turns, so be careful to
set it at the minimum setting).
Usually this setting is performed at the factory.
NOTE: With this setting when the exciter is switched on, the output power is about
2 Watt.