R.V.R. Electronica RX1-NV LCD, Руководство пользователя

Страница: 14 / 132

RX1-NV LCD
10 / 32
USER MANUAL Rev. 1.2 - 13/12/01
5.2 Preparation
Unpack the receiver and before any other operation make shure that no damage
due to the transport is present. In particular, inspect the conditions of all the
connectors.
Check if the mains voltage is correct for your site. The selector is on the rear panel
and the selected value is indicated by an arrow. If required, extract the fuse/selector
block levering with a little screwdriver. Rotate the block until the correct printed
value corresponds with the arrow, then reinsert it.
The correct value for the mains fuse is 2 A.
Verify that the mains switch of the unit is on the OFF position.
Connect to the RF input of the receiver the antenna cable. If your receiver includes
the double RF input option and you use only one antenna, we suggest to use the
input called A1.
Connect the mains power supply cable to the relative socket.
NOTE: this piece of equipment shall be correctly connected to earth.
This is necessary both for safety reasons and to obtain the receiver's correct
performances.
Finally, connect the audio output of the receiver to the devices that will use it,
depending on the configuration of your installation.
5.3 Operation
Warning: Before using the receiver for the first time, we suggest to get familiar
with the machine’s control system reading this manual in full, and specifically
chapter 7 (operating system).
Switch the receiver on using the switch on the front panel.
At start up, all the LEDs on the front panel are briefly switched on to permit the
verification of their functionality. The display then shows some information regarding
the model of the device (fig. 5.2).
Figure 5-2