R-Quest TCP-7450, Руководство пользователя

Страница: 30 / 37

Appendix A - Error Messages
Following is a list of error messages that may be displayed.
No HARD DISK !!
This would appear during the power up sequence if no hard disk could be
found. Check that the power cable is correctly installed on the hard disk, and
that the data cable is correctly connected between the hard disk and the copy
electronics. If in doubt, contact your
R-Quest authorized dealer.
!! ERROR !! No Writers Found
This suggests that either no writers are installed, or that they are incorrectly
installed. Check power to each recorder, and check that the SCSI cable is
correctly connected to each drive, and to the copy electronics.
For SCSI systems, ensure that every writer on a given bus has a unique SCSI
ID. If two SCSI devices have the same ID, they will not work.
For IDE systems, ensure that only one drive be connected to each cable.
!! ERROR !! - No disc in drive
The system cannot detect a Master disc in the drive. If there is a master in the
drive, the disc may require cleaning.
!! ERROR !! - Disc in drive appears to be blank
The system tried to read a Master, which appears to be blank. Check the
Master disc and try again. Again, the disc may require cleaning.
User Data Corrupt
The user set-up (including Duplication Options) is corrupted. The system will
automatically reset the options to the factory settings.
Job Cancelled
The user pressed the stop key.
!! WARNING !! Copier is in SIMULATE mode
The duplication options are set to simulate, and will NOT write to the media.
This means that the system will go through all the motions of writing discs, but
will not actually burn them. See the menu item
Set-up Menu | Duplication Options |
Burn CD
in the Operation section for more info.