R.P.S. Corporation MAGNUM series, Руководство по обслуживанию

Страница: 46 / 134

Magnum Service Manual V1.0
7
7-3
BRUSH DRIVE SYSTEM
INSTALLING & REMOVING BRUSHES
DISC MACHINES
With the machine turned on, turn off the brush deck switch. Turn machine power off.
Open the two latches on the jaws and swing them aside. Rotate each brush until both
tabs of the spring clip are accessible. Squeeze the two tabs together and the brush will
drop off. If the brush deck does not raise high enough to remove the brushes. Turn the
machine power on for 10 seconds and then off again. Then try removing the brushes
again. If the brushes still can not be removed due to lack of space the actuator or linkage
must be adjusted.
To install a brush reverse the procedure.
CYLINDRICAL DECK
With the brush deck raised, remove the side access door from the scrub deck. Grasp
the scrub brush and pull and it will slide off the brush driver and out from under the scrub
deck. To install brushes align brush with the brush drive and push until the brush slides
down onto the driver. Install the access door back onto the brushes. If the access door
does not fit up to the brush deck completely the brushes are not situated on the drivers
properly. Realign the brushes until they slip onto the drivers completely and the access
door sits tightly against the brush deck and latch will close easily.