Version 12.09.2019
HW:
CAM(V97)
RL3-UCON8-LV
P
a
g
e
15
2.6.1.
Audio insertion
This interface is only able to insert video signals into the factory infotainment. If an AV-
source is connected, the audio insertion has to be done by the factory audio AUX input or an
FM-modulator. The inserted video-signal can be activated simultaneously to each audio-
mode of the factory infotainment. If 2 AV sources shall be connected to the infotainment,
additional electronic is necessary to switch the audio signals.
2.6.2.
After-market rear-view camera
Some vehicles have a different reverse gear code on the CAN-bus which the video-interface
is not compatible with. Therefore, there are two different ways of installation. If the video
interface receives a signal of the reverse gear, the green wire
“Reverse-OUT”
of the 12pin
cable should carry +12V while the reverse gear is engaged. See the following illustration for
the according connection.
Note:
Do not forget to set dip5 of the video-interface to ON before testing.
