Version 22.08.2018
HW CAM(V31)/(V22)
RL2-RLINK
P
a
g
e
12
2.5.
Connection to the head unit- Power and CAN
Depending on the system (MediNav or RLink) there`re to different Power-and Can
connections required.
2.5.1.
MediaNav with 50pin Ribbon cable
Remove the vehicle`s monitor. The PNP Power/CAN harness is not usable with the MediaNav
system. Cut the enclosed 4pin Power / CAN cable near the PNP cable and add the stripped
ends to the according cables of the monitor’s factory harness, without cutting these original
cables of the vehicle. Use the 4pin cable diagram below.
Connect the stripped ends of the 4pin cable to Ground, B12V, CAN high- and
low, of the vehicle`s monitor harness, without cutting them.
2.5.2.
R-Link with 60pin ribbon cable
Disconnect the 24pin connector of the vehicle harness at the rear of Monitor and
connect it to the 24pin Connector of PNP Power/CAN Cable Kit.
Connect the 24pin-connector of PNP Power/CAN Cable to the 24pin-connector
at the Monitor`s Rear side.
Attach the daughter PCB at the outer side of monitor by using the enclosed longer
screws for perfect mounting.
For the MediaNav installation the enclosed PNP harness is not usable
!
