background image

(5)

Mounting the Filters & Membrane

STEP 5: Mounting the Filters & 

STEP 5: Mounting the Filters & 

Membrane

Screw the fi lters onto the mounting head starting from 

left to right in the order listed below, match ing the fi l ter 

label to the respective position la beled on the mount ing 

head.

Important: Remove the black protective cap from the 

mem brane before screwing in place.

Model

PreFilter Carbon     Membrane        PostFilter 

RO-QC3 

AWP5621 

     RO-QCM50

AWP56

33

RO-QC4 

AWP5605 AWP5633     RO-QCM50           AWP56

33

RO-QC4P 

AWP5

6

05 AWP5633     RO-QCM50        

   

AWP56

33

STEP 6: Tubing Connection

STEP 6: Tubing Connection

For RO Systems, determine the location for the storage 

tank.  A maximum distance from tank to faucet is 15 

feet.  The fastest fl ow at the faucet can be achieved 

by minimizing the length of the tubing from tank to 

faucet.

For ease of installation all tubing is 

individually labelled and colour coded .

1/4” Red -

Connects the feed water valve to the 

pre-fi lter.

3/8” Blue -

Connects the RO membrane 

product port to the stor age tank.

1/4” Black -

Connects the membrane brine port to 

the drain connector.

3/8” White -

Connects the postfi lter to the 

faucet.

3/8” Black -

Connects faucet to drain saddle under 

sink.

Fittings and Tubing

Fittings and Tubing

John Guest™ fi ttings are used throughout the system.

To insure an optimal seal, tubing should be cut with the 

end square.  An angled cut or distortion of the tubing will 

not provide an effi cient seal and may cause leaks.

To install a tube, push it through the collet until it seats 

fi rmly.  To remove a tube, push in the collet and pull out 

the tube.

STEP 7: Activating System for the First 

STEP 7: Activating System for the First 

Time

Make sure all water supply/drain lines are secure and 

free from leakage.  

Slowly turn the saddle valve counterclockwise until fully 

open.  Check stem seal for leakage.  If necessary tighten 

stem nut lightly.

Turn storage tank valve one quar ter turn counterclockwise 

to open the valve (the handle should be in line with the 

tubing as it enters the connection).

Open the product water faucet and let the water fl ow until 

all the air has been expelled from the system.  This will 

take about an hour for an RO system.

Close the product water faucet.  In 30 minutes, check the 

con nec tions for leaks and correct if necessary.

Содержание RO-QC3











Отзывы: