R. Beck Maschinenbau 191.100.00, Руководство по эксплуатации

Страница: 27 / 42

27
BA_BM_HS-300-LARGE_EN_45-21.docx
13 Maintenance and Repair
Maintenance and repair work may only be carried out by competent, trained and instructed personnel. If neces-
sary, further operating instructions and/or additional documents must be observed.
After maintenance or repair work on the lift table, always carry out a function test.
•
It is forbidden to reach under the lift table platform before it is secured
with the safety catch (see

section 13).
•
Model HS 300 LARGE | AH: Turn off the main switch before carrying out any mainte-
nance or repair work. WARNING! There is an acute risk of electric shock when open-
ing the battery box even if the main switch is turned off!
•
Wear safety shoes with steel-toed caps.
•
Wear suitable protective clothing.
Repair work on electrical, hydraulic, pneumatic and mechanical components may only be
carried out by authorised and trained personnel.

Before any maintenance and repair work is carried out, chapter

4 "Safety" must be read
carefully and observed.
13.1 Safety Catch for Securing
Figure 21: Safety catch
The safety catch is primarily used for securing during maintenance work that
has to be carried out under the lift table platform. This mainly includes the
replacement of the hydraulic cylinder.
Since the lift table can no longer be held when the cylinder is removed, it can
fall dangerously. For this reason, the safety catch must generally be used dur-
ing maintenance work in the scissor area and underneath the platform.
To secure the platform, fold the safety catch ( 7 ) all the way down in the di-
rection of the arrow (see

Figure 21).
13.1.1 Replacing the Hydraulic Cylinder
Move the lift table upwards until the safety catch ( 7 ) can be folded over. Then fold the safety catch all the way
down as shown in

Figure 21. Subsequently lower the lift table until the safety catches engage in the corre-
sponding catch points and the hydraulic cylinder is relieved resp. accessible for removal.
Stop! Do not work under the lift table platform until it is mechanically locked via the safety catch.
Non-compliance can result in life-threatening injuries.
13.2 Maintenance Intervals
Interval Action
Daily
Check all components for damage and have them replaced by competent personnel if neces-
sary. If you have any questions, please contact our support (phone: 0049 7576 / 962 978 - 0).
Monthly Lubricate the castors and bearings a little.
Annual
Make and document annual inspection of the lift table according to regulations.
7