Qvis Quattro, Руководство пользователя

Страница: 28 / 112

© Copyright QVIS ®. All documentation rights reserved. 21
Figure 2.5 QR code interface
Click ‘Next’ to bring up mode selection options.
Mode selection:
If you wish to setup a connection between the NVR and IP cameras via
computer network, you will need to make sure the NVR is connected to a router
or switch within the same network the IP cameras are connected to. Use an
Ethernet cable, which is plugged into the ‘Network’ port on the rear of the NVR,
and then connect it to an available Ethernet port on the rotuer/switch (see
Page
9 for rear panel diagram). The next stage to the guide configuration wizard will
display the ‘Mode selection’ options shown below in Figure 2.6.
Figure 2.6 mode selection

Quick set (recommended): NVR will automatically search, assign IP
address, and add any front end IP camera, saving you from further
connection setup.