© Copyright Qvis ®. All documentation rights reserved.
66
Alarm output:
when an alarm is triggered, system enables peripheral alarm devices.
Latch:
when motion detection has been detected, the system auto delays detecting for a
specified time. The value ranges from 1-300(Unit: second)
Show message:
System can pop up a message to alert you in the local host screen if you
have enabled this function.
Alarm upload:
System can upload the alarm signal to the network (including alarm centre)
if you have enabled this function.
Send email:
System can send out an email to alert you of when an alarm is triggered.
Record channel:
Select the channel to activate recording function once an alarm has been
triggered. Please make sure you have set
‘
MD record
’
in the encode interface(Main
Menu->Setting->Schedule) and scheduled to record in the manual record interface(Main
Menu->Advanced->Manual Record)
PTZ activation:
Here you can set the PTZ movement when an alarm has been triggered. The
System can go to a preset when there is an alarm. Click
‘
Select
’
button, you can see an
interface is shown as in Figure 5-.
Figure 5-65
Record Delay:
System can delay the record for specified time after alarm has ended. The
value ranges from 10s to 300s.
Tour:
Here you can enable a tour function when an alarm is triggered. System one-window
tour. Please go to
chapter 5.3.9
to display tour interval setup.
Snapshot:
You can enable this function to take a snapshot of an image when motion detect
alarm is triggered.
Please highlight icon
to select the corresponding function. After all the setup are complete
please click the save button, system goes back to the previous menu.
Note:
In motion detection mode, you cannot use copy/paste to set channel setup since the video
in each channel may not be the same.
In Figure 5-60, you can left click mouse and then drag it to set a region for motion detection. Click
Fn
to switch between arm/withdraw motion detection. After setting, click
‘Enter’ key to exit.
