© Copyright Qvis ®. All documentation rights reserved.
17
Figure 3
– 8 Side cable exit hole
In special circumstances, the installer may need the metal protection tube to protect themself when he pulls
through the cable from the side cable (PG11 screw thread port is provided). Please remove the plastic
decoration plug from the side panel of the chassis and pull through the cable to the tunnel of the PG11
screw thread. Now secure the tunnel in the PG11 screw threaded hole of the device.
3.2.7 Cable Connection
There are two reserve cable exits
provided on the camera’s chassis. The pin diameter should be no less
than 15mm. One of the cable exits has a M22 screw thread and can work with the default combination
cable to remove the risk of the dragging and pulling of the cable.
Also provided are two waterproof airproof plugs (One of the default positions is the cable exit on the device
chassis and the other is in the accessories bag.). The waterproof airproof plug has two functions; one is to
fill in the cable exit and the other is to help pull through the cable. It supports the cable, which has a
diameter range from 4.0~6.0 mm. This will help you to do the waterproofing work when you pull the cable
through your own exit. Please refer to the steps listed:
Step 1
Take the waterproof airproof plug out, pull the cable (diameter ranges from 4.0 to 6.0 mm) through the
waterproof airproof plug (see Figure 3
– 9).
Figure 3- 9 Cable connection
Dig through here
