© Copyright Qvis ®. All documentation rights reserved.
16
Line up the dome camera protection enclosure to the cable exit on the side panel. Put the enclosure back
and then use the inner hex wrench to secure the 3 inner hex screws firmly. Now the installation is complete.
Note:
Usually we recommend, after the installation, to take the three white static protection gaskets from the
accessories bag and insert them to the screw holes of the protection enclosure. This will enhance enhance
the device
’s reliability.
3.2.5 Manual Zoom Lens Focus Operation
The manual zoom lens focus interface is shown as in Figure 3-7.
Step 1
Slightly loosen the adjusting screw
E
and push the adjust screw
E
to make it swing. Adjust the lens focus to
the proper position according to the displayed video.
Step 2
Slightly loosen the adjusting screw
F
and push the adjust screw
F
to make it swing. Adjust the lens to get
the clear video and then fix the adjusting screw firmly.
Step 3
When you are securing the adjusting screw
F
, you can see the video may become blur. Please push the
adjusting screw E to adjust the video slightly. Please secure the adjust screw E if you get a clear video.
Figure 3
– 7 Manual zoom lens operation
3.2.6 Side Cable Exit
If you adopt a side cable exit when you are installing the device, you need to remove the plastic decoration
plug from the side of the chassis. Use the proper tool to dig through the part specified in Figure 3-7 to form
a cable exit. Put the plastic decoration plug back to the chassis and then pull the cable through the side
panel of the chassis.
Adjusting screw E
Adjusting screw F
