QVI Cobra DRS-300, Руководство пользователя

Страница: 92 / 100

Appendix B
Focusing and
Aligning the Camera
This appendix only applies to Cobra systems equipped with the video camera
option, and describes how to focus and align the camera.
Focusing the Camera
To focus the camera, follow the steps below. You will need a 2 mm hex key
(Allen) wrench.
1. Power up your Cobra system and access Scan-X.
2. Use the Focus Indicator in Scan-X to focus the sensor over the surface of a
part. Observe the image of the part on the LCD screen.
On-line Help:
See the topic, How to Focus the Sensor , for more information.
-
If the image is sharp and in focus, stop here . You do not need to
perform the rest of this procedure.
-
If the image is not sharp and not in focus, continue with Step 3 of this
procedure.
3. Use the Locking knob to lock the Z axis slide and sensor in position, as
described in Section 3.
4. Use a 2 mm hex key (Allen) wrench to remove the four screws securing the
camera cover to the camera assembly (see Figure 2-4 on page 2-6).
Focusing and Aligning the Camera B-1
Focusing
&
A
ligning
the
Camera