QVI Cobra DRS-300, Руководство пользователя

Страница: 25 / 100

4. Unpack the DRS laser sensor you want to mount.
-
If you purchased the video camera option, perform the Mounting the
Video Camera and LCD Screen Assemblies procedure that starts on
page 2-6.
-
If you did not purchase the video camera option, continue with Step 5
of this procedure.
5. Mount the laser sensor onto the sensor mounting pad. Use the two
positioning pins to align the sensor correctly over the mounting holes, see
Figure 2-2 below.
Note: Mount the sensor so that the laser sensor connector is on the left side of
the sensor as shown in Figure 2-2.
6. Insert the three mounting screws into the mounting holes, and tighten firmly
with a 3 mm hex key (Allen) wrench.
Never connect or disconnect the laser sensor cable from the top of the sensor
while power is applied to Cobra. Doing so can seriously damage the sensor.
7. Connect the laser sensor cable to the top of the sensor as shown in
Figure 2-3 on the following page.
2-4 Installation and Setup
Figure 2-2. Installing the Sensor