5. ELECTRICAL CONNECTIONS
Fig. 6
Receiver
Fan
Outlet box
Wall control
Ceiling
REMEMBER
-Turn off the power!
ON
HI
MED
REV
LOW
FAN OFF
LIGHT
OFF
ON
WH
WH
BLK
BLK
BLK
House
supply
wire
GRN
GROUND
GRN
Find the DIP switches located on side of
the wall control unit. Ensure the setting
matches the switch setting on the receiver.
Carefully tuck the connected wires
inside the junction box. Secure the
transmitter with the two screws provided.
Attach the face plate over the transmitter
with the two screws provided.
4.
The wall control and receiver unit has
16 different code combinations.
Your fan will not operate if the switch
settings do not match.
If you have another remote operated fan in
your home, make sure its combination of
switch settings are different from those of
your new fan.
Use the wire nuts supplied with your fan
when making connections. Secure the
connectors with electrical tape and make
sure there are no loose connections or wire
strands.
1.
Find the DIP switches located on the
side of the receiver unit. Set the switches
at random to set the frequency at which the
unit will operate. At least one of the four
switches must be in the "ON" position.
2.
Connect the wiring from the ceiling to
the receiver unit. (Use the 2 wire bundle
on the receiver.) Secure with supplied wire
nuts. (Fig. 6)
Connect the BLACK building
supply wire to the BLACK receiver
wire.
Connect the WHITE receiver neutral
wire to the WHITE building neutral wire.
Connect the COPPER building
ground wire to the GREEN fan ground
wire.
3.
Connect the wiring from the wall
switch receptacle to wall transmitter unit.
Remove the existing wall plate and
switch from the wall junction box.
Connect one BLACK wire from the
wall to one BLACK wire (labeled "TO
FAN") from the wall transmitter.
Connect the other BLACK wire
(labeled "TO POWER SUPPLY")
from the transmitter to the remaining
BLACK wire from the wall (A/C
supply source).
If your junction box has a ground
wire (green or bare copper), connect
the transmitter's ground wire to it.
Otherwise, connect the transmitter
ground wire directly to one of the
screws from the outlet box.
NOTE:
It may be necessary to
bind the house wires to the
corresponding receiver wires
with electrical tape before
capping them with wire nuts.
This will prevent them from
slipping apart during the rest of
the installation.
