1.
Make sure the wiring is safely inside the
outlet box as instructed in
Step 5 -
Electrical Connections.
To install the
canopy, slide the canopy up to hanger
bracket and place the key hole on the
canopy over the screw on the hanger
bracket, turn canopy until it locks in place
at the narrow section of the key holes. (Fig.
9) Align the circular hole on canopy with
the remaining hole on the hanger bracket,
secure by tightening the two set screws, lift
canopy cover and attach by turning
clockwise.
Note:
Adjust the canopy screws
as necessary until the canopy and canopy
cover are snug. (Fig. 9)
2. Installing the Blades
Insert the blade through the access window
from the blade holder. Align holes from the
blade and motor and secure with screws and
blade support plate. Repeat process with the
other blades. (Fig. 10)
DO NOT bend the
blade arms when installing the blades.
3. Attaching the Motor Bottom Housing
Attach the botttom housing to the mounting
ring of the motor by using the three screws
provided that are pre-installed on the
mounting ring. (Fig. 11)
4. Attaching the Control Cup
Attach the control cup to the flange of the
motor by using the three screws provided
that are pre-installed on the flange.
(Fig. 12)
5. Attaching the Control Cup Plate
Attach the control cup plate to the control
cup with the decorative screw provided.
(Fig. 13)
6. COMPLETING
THE
INSTALLATION
Fig. 10
Screws
Blade support
plates
Blades
Fig. 9
Outlet box
Hanger
bracket
Canopy
Canopy cover
Screws
Screws
Control cup
Decorative screw
Fig. 12
Control
cup plate
Flange
Screws
Fig. 11
Screws
Mounting
ring
Motor
bottom
housing
