QUORION QMP 3000, Руководство пользователя

Страница: 35 / 55

35
7.2 Easy Programming
The register has a special program mode which can used by a clerk with Manager
authority or when the Central Lock is in the MANAGER ( M ) position. The mode is started
by entering the mode number on the SUBTOTAL key. When the mode is not active
ERROR#1 (Invalid Entry) is shown otherwise the register will print the mode on the receipt,
journal and electronic journal.
When the register is in Easy Programming Mode you can only exit this mode by either
turning the Central Lock, remove the Clerk Key or by pressing the SUBTOTAL key without
entry.
In mode 1, 2, 3 or 4 you must:
1 - Enter the new data
2 - Press SUBTOTAL
3 - Press a direct PLU key or enter the number on the PLU# key.
4 - Continue with next entry or exit by pressing SUBTOTAL without entry.
MODE 1
In this mode you can program the Plu Prices. The price of the active level is programmed.
When you want the program a price of another level (when active) you must select the
level first.
MODE 2
In this mode you can program the Plu Cost Prices.
MODE 3
In this mode you can program the first Plu Descriptor.
MODE 4
In this mode you can program the second Plu Descriptor.
MODE 5
In this mode you can program the Plu Department Selection.
MODE 6
In this mode you can add inventory to the PLU Inventory total when active.
MODE 7
In this mode you can subtract inventory from the PLU Inventory total when active.
MODE 8
In this mode you can change the Minimum PLU Inventory Level when active.
MODE 100, 101, 102 and 103
These modes are used for PLU file maintenance when Scanning Codes are used.
7.3 Programming Files
Programming the individual files using the keyboard is done by using the UP, DOWN,
PGUP, PGDN, TYPE (program type), X and CR (User Report) key.
You can only program when the Central Lock is in X, Z or T position. You start
programming by either entering the FILE# directly on the TYPE key or by pressing the
TYPE key without entry which will open the programming window and you can select the
file you want to program. Files which are not active in the configuration of the application
will not be shown. At the end of the line the File# number is also shown for reference.