2of2
2018 QuoizelInc.
ReleasedDate:2018-10-08
visit us on-line at www.quoizel.com
STEP 4 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
STEP 5 - Install the Fixture Body
A. Position the backplate and Fixture Body (C) onto the Crossbar
Assembly (A). Place the holes in the backplate over the mounting
screws or alternative short mounting screws. Secure the Fixture
Figure 5
STEP 6
Install Bulb and
-
Apply
Silicone Sealer
A. Insert the bulb onto the socket
and screw snugly into place.
B. Make sure the exterior wall
surface and fixture backplate
are free of dirt before applying
caulk. Using exterior grade
caulk, caulk over top of
backplate and down both sides.
Do not caulk the bottom of the
fixture backplate to ensure
proper moisture drainage.
Your fixture is now assembled
and ready to use. Enjoy!
Exterior
Grade Caulk
Exterior
Grade Caulk
Backplate
Figure 6
T9 Vintage Bulb
(recommended
but not included)
Socket
Figure 4
WVR8407A
FINISH: ANTIQUE BRASS
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4
"
Fixture can
only be
mounted in
the direction
indicated
4.5”
2.5”
7”
20”
8.5”
Mounting Ball
A
Backplate
C
Mounting Screw
or Alternate Short
Mounting Screw
Body by using
the mounting
balls and hand
tighten the
mounting balls
until snug.
7”
7”
