1of3
For Style RO1914IZ
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Please go to
for product cleaning tips. Go to the
selection.
(3) B10 Candelabra Base Bulbs 60W Maximum, Candelabra Base T8 Vintage Bulbs are recommended, bulbs not included.
Minimum Hanging Height is 32”, Maximum Hanging Height is 130”.
30-45 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact your original place of purchase.
www.quoizel.com
Care + Maintenance
Light Source:
Fixture Hanging Height:
Estimated Assembly Time:
Preparation:
Tools Required:
Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Installation Guide #IS-RO1914IZ
2019 QuoizelInc.
ReleasedDate:2019-02-22
visit us on-line at www.quoizel.com
Package Contents
A
Side Rod
x 2
Hardware Contents
AA
Crossbar
Assembly
x 1
BB
CC
Ceiling
Canopy
x 1
Fixture Chain
x 1
Quick Link
x 2
DD
B
Lock Screw
x 4
STEP 1
-
Install Glass Panel
A. Insert the Glass Panel (F) into the slot
in the bottom edge of the Cage (E) and
press the tabs on the top edge of the
Cage (E) onto the top edge of the Glass
Panel (F) to secure it.
Figure 1
Fixture Loop
x 1
E
C
Fixture Body
x 1
Fixture
Holder
x 1
D
C
D
STEP 2
-
Remove Papers Inside of the Cage
A. Rotate the bolt and remove it from the bolt holder to open the door.
B. Remove papers inside of the cage.
C. Close the door and place the bolt back onto the bolt holder.
Figure 2
Door
Bolt
Bolt Holder
Paper
(Remove)
STEP 3
-
Install the Crossbar Assembly to Outlet Box and Adjust
the length of the Nipple
A. Attach the Crossbar Assembly (AA) to the Outlet Box with the head
of the Green Ground Screw facing you. Secure it with Outlet Box
Screws (not included), tighten until snug
B. Adjust the hex nut and lock washer underside of the crossbar to the
middle of the nipple.
C. Remove the canopy lock ring from the canopy chain loop. Place the
Ceiling Canopy (DD) over the canopy chain loop against the ceiling
to determine the correct position of the nipple. Thread the canopy
lock ring onto the canopy chain loop. Adjust the nipple to allow the
Ceiling Canopy (DD) to rest against the ceiling when held in place
.
Outlet Box Screw
(not included)
Hex Nut and
Lock Washer
Outlet Box
Green Ground Screw
Canopy Chain Loop
Canopy Lock Ring
Nipple
DD
AA
Figure 3
