4
CARE AND MAINTENANCE
Wipe clean using soft, dry cloth or static duster. Always avoid using harsh chemicals and abrasives to clean
fixture as they may damage the finish.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Bulbs will not light.
Fuse blows or the
circuit breaker trips
when light is turned
on.
1. Bulb is burned out.
2. Power is off.
3. Faulty wire connection.
4. Faulty switch.
Crossed wires or power wire is
grounding out.
1
. Replace light bulb.
2. Make sure power supply is on.
3. Check wiring.
4. Test or replace the switch.
Check wire connection.
2018 QuoizelInc.
Silicone Sealer
Exterior Wall Surface
Fixture Backplate
Your installation is now complete! Restore electricity
and save this sheet for future reference.
Fixture Body
Glass
Lock Screw
Cage
Glass replacement:
Note
: Place a cloth or towel on the ground under the
work area to prevent loss of mounting hardware if
dropped.
a. Remove lock screw, cage, glass from the fixture body.
b. Remove the glass and add the replacement into the
same position.
c. Attach the cage with the glass back onto the fixture body
and secure with lock screws.
STEP 5:
NOTE:
To ensure proper moisture drainage, do not seal
bottom of fixture backplate.
a. Make sure the surface of the exterior wall and fixture
backplate are free of dirt.
b. Using silicone sealer (not included) start on one side of
fixture backplate and follow contour where the fixture
backplate meets the exterior wall surface.
c. Proceed to seal around backplate.
d. Place silicone sealant over the head of each mounting
screw and mounting holes on the backplate.
Printed in China
