Plug the oven into a grounded outlet rated for your unit's labeled voltage. A separate circuit or breaker should be
dedicated for the oven.
Do NOT modify the provide plug. Do NOT use an extension cord.
Position the unit in its ultimate operating location. Maintain a minimum of
4" of airspace around the unit and a minimum of 18" above the unit’s motor
cover. The portholes at the top of the unit will expel a small amount of warm air
through forced convection.
(FIG.1)
The unit is ready for your immediate use and no adjustments are necessary. For normal operation and temperature setting
follow the steps below.
1.
Turn the power switch to the ON (UP) position by pressing on the rocker switch.
2.
Rotate the oven’s dial clockwise to a number setting (
10AF series
) or temperature setting to start the heating process.
Safety Precautions
Set-Up & Installation
General Operation
FIG. 2
Read Operating Instructions thoroughly prior to operation
Use only a grounded outlet that is rated for your model's electrical requirement.
Do not modify the oven or factory control settings to operate the oven above the stated maximum operating
temperature.
Exterior surfaces of the oven may become hot to the touch when operating at higher set temperatures.
Do not leave the oven unattended during operation.
Do not place volatile or combustible materials inside the oven.
Do not use any flammable solvents or gases or materials that may contain flammable solvents or gases, or with
liquids, vapors or chemicals that produce toxic gases.
Do not use open liquids in the oven.
Conduct periodic maintenance as required.
WARNING
Warns of a possible electrical shock
IMPORTANT
Refers to an important note in the usage of the unit
WARNING
Warns of a possible risk of fire
CAUTION
Cautions of HOT exterior surface during operation
WARNING
Warns of possible injury or muscle strains, use assistance when moving or lifting
Operate the oven in accordance with all state, local, and federal laws that may govern its usage for your specific
application. Observe the following safety precautions:
PAGE 2
Exhaust ports
Upper fan
plenum
Motor cover
Heater
Rear fresh air
intake vents
Install the adjustable shelf by placing the ends of the wire shelf bracket into the
corresponding holes located on the inner sides of the oven at the desired
height. Push the ends of the bracket into the holes until the first bends in the
bracket are against the wall, then rotate the bracket down. Place the shelf on
the brackets.
(FIG 2)
The exhaust ports should NOT be used as chamber access for
temperature-measuring probes. Insertion of any such probe or
device may damage or unbalance the circulating fan blade at the
top of the oven chamber.
Do not cover or place anything on the top surface of the motor
cover. This can cause the motor in the oven to severely overheat
risking the possibility of fire.
A
B
C
D
FIG. 1
