Section IV - Operating Procedures
Starting the Interface Program
Once connection is established between
the controller and the host PC as instructed
in Section III - Installation, switch the power
to the controller on. Launch the dryer
application software by double clicking the
CD icon on the PC desktop or by clicking:
Start > Programs > Quincy > Dryer
Application Software.
The first time the software is used the
following window will appear.
Choose your preferred language by
clicking the appropriate flag.
The screen below will be displayed.
Click the “Establish Communication”
button on the screen to establish the link
between the PC and the dryer controller.
The serial number on the software must
match the serial number on the controller
to allow communications to be established.
If communication cannot be made, a
warning will appear at the bottom of the
screen.
Lack of communication may be due to one
of the following:
Poor connections to the controller
Controller switched off
Application software/controller serial
number mismatched
Once communication has been
established, click the “Read SFD” button
on the screen to display the default
settings or the last settings saved.
It is possible to change some of the
controller settings from the factory default
settings, however, this should only be done
by a qualified service technician.
•
•
•
Quincy Compressor-QMOD
15
