Owner’s Manual
Please review the following instructions and make yourself
familiar with the parts and function of your Quik Shade® canopy.
Parts included:
[1] assembled canopy frame
[1] fabric canopy top
[1] storage bag
[4] stakes
– Step 1: Place your
QUIK SHADE® in the center of the
set-up area. With a partner on the
opposite side of the frame, hold
onto the two outer legs and lift
slightly for clearance. Take a few
steps back until you extend the
frame to a full arm’s length –
approximately four feet (Fig. A).
Step 2: Open the canopy to
about 80% (Fig. B). Install your
top at this point.
Step 3: Open the frame the rest
of the way by pushing on the top
and bottom of a diamond (Fig. C).
Be sure your partner is directly
across from you. Open the frame
completely by pressing down on
the corner cap while pushing up
where the eave meets the slider
(Fig. D).
Step 4: Align the hook and loop patches at each corner (Fig. E).
Step 5: Pull the inner leg out to extend the height of the canopy to
Step 6: Extend the legs of your canopy to the desired height.
Use stakes to secure frame to the ground if necessary.
Step 7: Fill out included product information card with a stapled
copy of your receipt and store in a safe place. Product information
can be found on the sticker located on the eave of the frame (Fig. G).
Go to shelterlogic.com/support/forms/product-registration/
and register your new canopy. If you have any issues setting up
your canopy, have questions, need parts or accessories call our
toll-free service line (888) 288-2345.
TAKE DOWN – Step 1: Remove stakes from
the ground. Reduce legs to their lowest
position by pressing the push buttons (Fig. H).
Step 2: At each corner, pull the ring on
the pull pin to release the sliders. (Fig. I)
Be careful not to pinch your hands by
staying away from the bottom part of the
slider (where the plastic ends). The slider
may move fast once released. If the slider is
slider while releasing the pull pin.
Step 3: Lift the canopy slightly and slowly
walk towards your partner as the frame
folds in. Keep walking until the frame is
about halfway closed. Be sure to avoid
outside legs and continue closing canopy
as you walk towards your partner. The
completely folded canopy should stand
on it’s own (Fig. J).
Step 4: With the canopy standing, unzip
the wheeled bag and slide bag down slowly
until entire canopy is in. Invert the canopy,
Note:
The canopy top may remain in place
for easier subsequent set-up. However, to
prolong the life of the fabric, we recommend
that you remove the top when storing
your canopy.
Example
G
A
B
C
D
E
F
H
I
J
K
