QuickWorldWide Big Quick 50 Sport, Руководство по сборке и обслуживанию

Страница: 49 / 79

5-4 TAIL INSTALLATION
No. Bag# Description Qt.
1 Step 4 Assembly up to step 4 1
2 Step 5-3 Tail Assembly 1
3 In box Boom Support 2
4 5 Boom Support End 4
5 HB M3x12 Cap Head Bolt 2
6 HB M3x8 Cap Head Bolt 2
7 HB M3 Locknut 6
8 HB M3X45 Cap Head Bolt 4
9 5 Boom Holder 2
10***** CA Glue 1
•
Note for installing the timing belt: Turn the Tail assembly so that the Tail Output Shaft
pointing upward put the belt onto the Transmission, then twist the Tail Assembly 90
o
to the right. Make sure the belt not too tight or loose. Tighten the four screws on the
boom holders.
•
Measure the Boom Support carefully before cutting. It is a good idea if you install one
end of the rod first, then make the measure then cut it. Remember apply CA Glue for
the rods when installing into the Support Ends.
Note: Frames may look differently from the one in ki
Page 49 of 79