Quicksilver MAX Sprint, Инструкция по сборке

Страница: 35 / 124

CASTLE NUTS AND COTTER PINS
WARNING : ANY BOLT ON THE AIRCRAFT WHICH IS SUBJECT TO ROTATION USE MUST
USE A 'CASTLE NUT'. A CASTLE NUT RELIES ON A COTTER PIN TO KEEP IT FROM
BACKING OFF. ENSURE ALL CASTLE NUTS ARE SECURED WITH COTTER PINS!
ALL COTTER PINS MUST BE BENT CORRECTLY.
COTTER PINS
Refer to the figures below for the proper method of bending all Cotter Pins, Quicksilver Part
Number (P/N) 10635.
WARNING: NEVER RE-USE A COTTER PIN AFTER IT HAS BEEN BENT.
Clevis Pin (or T-Handle Pin)
Correctly secured with Cotter Pin Castle Nut correctly secured
with a Cotter Pin
THREAD ADHESIVE
Thread adhesive (Loctite 290 ) may be supplied with the kit and is required on ALL threaded
fixtures (bolts, push/pull control cable, rod end bearings etc.) WITHOUT self-locking mechanisms.
Examples of locking mechanisms are: Locknuts or Castle Nuts secured with a cotter pin or safety
wire.
ALL JAM NUTS REQUIRE THREAD ADHESIVE
ONE or TWO drop of thread adhesive located on the threaded portion of a bolt is typically sufficient
when applying during construction.
IMPORTANT: When using with push/pull control cables or other threaded fittings, ensure the
thread adhesive is applied to an area where it will make contact with the nut in its
locked position.
Section 1
6
Air-Tech, Inc