QuickLabel Systems pronto! 482, Руководство пользователя

Страница: 101 / 256

Pronto! 482/486/682/863 8-11
1 To rewind directly onto the rewind axle the spring (21) must be removed.
Loosen the screws (20) and remove the spring (21).
2 Feed the label strip over the guide bar (16) and under the roller (18) to the
rewind axle (15). Ensure that the label strip is even with the disc (14).
3 Attach the label strip appropriately to the rewind axle by sliding the
clamp (3) over the label strip with the clamp set in the groove of the
rewind axle (15).
Consider the required method of rewinding:
• The broken line is valid for inside wound labels.
• The full line is valid for outside wound labels.
4 Slide the clamp (3) as far as possible towards the disc (14).
5 Slide the flange (2) onto the rewind axle so that it slightly touches the
label strip. The label strip must be able to move slightly between the disc
and the flange.
6 Tighten the knurled screw (17) on the flange.
7 The rewinder is ready for operation. If the printer carries out a paper feed
the rewinder also starts to operate.