QuickJack 3500SLX, Руководство по установке и эксплуатации

Страница: 46 / 144

QuickJack™ Portable Car Jack
46
P/N 5900263 — Rev. B6 —September 2023
Lowering the Frames from the Top Locking Position
Lowering the QuickJack’s Frames from the Top Locking Position is different from lowering them from
the First Locking Position, so it is described separately.
⚠
DANGER Keep hands clear of all pinch points!
⚠
WARNING When lowering QuickJack Frames, make sure the Lock Bar and the Release Cam
stay in their Lock Channel. If they get knocked sideways, they can get stuck on the
rail of the Lock Channel, which results in the QuickJack not lowering correctly.
To lower the QuickJack Frames from the Top Locking Position :
1. Press and hold
Up
until the Lock Bar is off the Lock Block, then release
Up
.
2. Raise the Lock Bar on both QuickJack Frames so that the Release Cam is on top of the Lock
Block on both Frames, as shown below.
You can use your hand or your foot to raise the Lock Bar.
Not drawn to scale. Not all components shown. Release Cam shown on top of the Lock Block.
3. When the Release Cam is on top of the Lock Block on both Frames, press and hold Down until
both QuickJack Frames lower to the ground.
If the Lock Bars engage on the Lock Block as the Frames go back down, start the process over
again.
If one side re-engages on the Lock Block but the other does not, immediately release
Down and
then start the process again. If this issue continues, refer to Troubleshooting .
Note : Always press Down for ≈5 seconds after the Frames are on the ground ; this
ensures that as much Hydraulic Fluid as possible returns to the Fluid Reservoir.
4. Remove the QuickJack Frames from under the Vehicle; use the Quick Frame Handles.
5. Move the Vehicle, if desired.
⚠
CAUTION Do not drive the Vehicle on the QuickJack Frames or the Hydraulic Hoses.