G
I
J
3
H
C
2
A
1
B
NOTE–
Setting the wheelchair on a table or on a flat surface, such as a workbench, helps make these proce-
dures easier.
NOTE ON TORQUE SETTING–
A torque setting is the optimum tightening which should be made on a
particular fastener. A torque wrench which measures in./lbs. should be used when tightening fas-
teners on Quickie/Zippie wheelchairs. Unless otherwise noted, use a torque setting of 60 in./lbs.
When setting up this wheelchair.
A. SWING-IN/SWING-OUT HANGERS AND FOOTRESTS
(60°, 70º, 80°)
NOTE–
60° hangers are only available on the Zippie IRIS.
1. Installation
a. Place swing-in/swing-out pivot saddle into the receiver on front frame tube with the footrest
facing outward from the frame. (
-A)
b. Rotate the footrest inward until it locks into place on locking bolt. (
-B)
2. Removal
a. To remove footrest, push release latch toward the frame.
b. Rotate footrest inward and lift. Or, pull release latch away from frame and rotate outward.
3. Height Adjustment
NOTE–
It is recommended that you maintain a minimum of 2.0 inches between the lowest point on the
footrest and the floor.
a. Loosen set screw (C) using a 3/16 inch hex key.
b. Slide footrest extension up or down inside frame tube to desired height.
c. Tighten set screw. Use a torque setting of 144 in-lbs (16.27 Nm).
B. HEAVY-DUTY, LIFT-OFF FOOTRESTS
(optional)
1. Installation
Slide pivot saddle (G) into receiver (H) on front frame tube until it locks into place.
2. Removal
To remove footrest, push release latch (I) while lifting up footrest from receiver.
3. Height-Adjustment, Front Mount
a. Loosen and remove the retaining bolt (J) in the footrest mounting bracket.
b. Position footplate upward or downward in predrilled holes on hanger tube.
c. Reinsert bolt and tighten.
3
2
1
1
1
1
2
IX. SET-UP & ADJUSTMENT
ENGLISH
13
113373 Rev. C
