A. ADAPTIVE FOOTPLATE ANGLE ADJUSTMENT
If there is already an Adaptive Flip-back Footplate installed on the chair. You will simply
need to adjust the angle(A) of the footplate for the support and comfort of the user.
1. Setting the foot angle
a. Place your wheelchair on a table or flat work surface for best results.
b. Using a 2.5mm, and 4mm hex key, loosen the two set screws(B), and the clamp
screws(C) slightly, and adjust the footplate to the correct angle.
c. Make sure the clamp screws(C) are tight,ened to 55 in-lbs and tighten the set
screws(B) to a maximum of 40 in-lbs (do not over-tighten).
NOTE–The footplate should be able to move freely and flip-back if needed.
The angle
adjustment depends on the location of the socket head screws (D) which
act as stops for the footplate to set the angle.
DO NOT overtighten the set screws! This can damage the footplate.
B. ADAPTIVE FLIP-BACK FOOTPLATE INSTALLATION
Here you will find the instructions necessary to install the Adaptive Flip-back Footplate kit
on your chair. After you are done, you will simply need to adjust the angle of the footplate
as shown above, for the support and comfort of the user.
1. Remove your existing Footplate/Footrest assembly.
a. Place your Wheelchair on a Table or Flat work surface for best installation results.
b. Using a 4mm Hex Key, Loosen the set screws(E) and remove the old footplate and
footrest tube assembly from the front frame of your chair.
2
1
3
4
5
Tools needed:
a. 2.5 and 4mm hex key
b. 10mm wrench
c. Torque wrench and hex bits
Please read these instructions carefully before beginning the installation. Failure to understand and follow installation instructions
may result in injury to installer and/or end user and may void the warranty. For more information on components, or If you
have any questions, call Sunrise Medical Technical support at 800-333-4000 or go to www.sunrisemedical.com.
1
Front
A
2
Parts included in the Kit:
1. 1x Angle Adjust Footplate Assembly
2. 1x Footplate (standard or carbon)
3. 2x Footplate Mount Tube Assembly
4. 2x Straight Footrest tube (Option)
B
3
C
E
ZONE/Q7/7R ADAPTIVE FLIP-BACK FOOTPLATE
ADJUSTMENT AND INSTALLATION
D
Side View
