930360 Rev. F
17
E NG LI S H
M. SWING-IN/OUT HANGERS AND FOOTRERSTS
(60°, 70°, 70° “V”, or 90°)
1. Installation
a.
Place swing-in/swing-out pivot saddle into the receiver (A) on front frame tube with the footrest
facing outward from the frame.
b.
Rotate the footrest inward until it locks into place on locking bolt.
2. Removal
a.
To remove footrest, push release latch (B) toward the frame.
b.
Rotate footrest inward and lift. Or, pull footrest away from frame and rotate outward.
3. Height Adjustment
NOTE– It is recommended that you maintain a minimum of 2.0 inches between the lowest point on the
footrest and the floor.
a.
Loosen set screw (C) using a 3/16 inch hex key.
b.
Slide footrest extension up or down inside frame tube to desired height.
c.
Tighten set screw. Use a torque setting of 144 in-lbs (16.27 Nm).
N. ARTICULATING OR ELEVATING LEGREST
1. Installation
a.
To install or remove the Articulating legrest (ALR) or elevating legrest (ELR) see instructions above for
(Swing-in/out hangers and Footrests)
2. Adjustment
a.
To raise legrest, lift to desired position. Legrest will automatically lock in place.
b.
To Lower, while seated in the chair, press the release lever (D) forward and lower legrest to desired
position, the legrest will automatically lock in place.
O. BACKREST
Quickie LXI wheelchairs are shipped with an 8º bend.
P. CUSHION (option)
Installation
a.
Place cushion on seat sling with VELCRO
®
side down. The beveled edge of the cushion should be in
front.
b
Press firmly into place.
WARNING
P
ossible pinch point. If seat sling is not present during folding or unfolding, pinch top of seat rail
securely without wrapping fingers around the seat rail. Use flat palms to depress the chair
if opening.
20
21
22
Articulating Legrest
Elevating Legrest
21
22
20
VIII. USE AND MAINTENANCE
A
B
C
D
D
