Quicke Q 910 US, Руководство оператора

Страница: 7 / 171

ENGLISH (106-501
)
106
WARNING
1123492 C
To prevent rollback onto operator
- use special loader attachments
for handling large objects such as
stumps and large round bales.
Transport load as low as possible
to avoid overturning.
Part No. 1123492 C
Part No. 1123493 C
1123493 C
DANGER
Keep machine clear of
overhead power lines to
avoid death or serious
injury.
Part No. 1123491 C
CAUTION
1123522 C
ALWAYS make sure the imple-
ment is LOCKED on the Tool
Carrier before beginning loader
operation.
This can be checked by obser-
ving the locking lever position
and forcing the implement
against the ground using the
loader hydraulic cylinders.
Failure to properly install imple-
ment can cause the implement
to come off the Tool Carrier
resulting in serious injury to the
operator or bystanders.
Part No. 1123522 C
WARNING
1. Add recommended rear wheel
ballast and/or rear counter -
weight for stability .
2. Move wheels to widest recom -
mended setting to increase
stability.
3. Move and turn tractor at low
speeds.
4. In transport carry the load
low.
5. Lower loader to the ground
when parked.
6. Before servicing or adjusting
equipment;
* lower loader to the ground.
* shut of f engine.
7. Relieve hydraulic pressure
before disconnecting oil lines.
8. Observe safety recommend -
ations in Loader Operations
Manual.
1123491 C
(USA / CANADA)
(EUROPE)
(All countries)
11 23 673 1123673
!
11 23 674
Part No. 1123674 Part No. 1123673
WARNING !!
Check that the implement is locked.
VARNING !!
Kontrollera att redskapet är fastlåst.
ACHTUNG !!
Arretierung des Arbeitsgerätes prüfen.
VAROITUS !!
Takista että varuste on lukittunut.
ATTENTION !!
Veillez au verrouillage de láccessoire.
1123390
Part No. 1123390
CHECK LIST
When the loader has been fitted - check that everything
works properly before use. Always check the following
points. Tick off one by one and adjust , if necessary.
1. Check that the mounting has been carried out
according to the mounting instructions.
2. Check the counter-weight with regard to
implements and field of application.
3. Check that all screws have been tightened.
4. Check that the front wheels don't interfere with
loader and subframe at max. turning angle and
oscillation - if NOT, install front axle stop pieces or
limit the turning angle.
5. Test run of loader.
6. Check that there is no oil leakage.
7. Check oil level in tractor - if necessary, re-fill.
8. When attaching an implement, check that the
locking pins cam in.
9. Check that there are no visible damages on the
loader.
Depending on the regulations /
laws in each country there are
various types of warning decals, of
which these only represent a
selection.
Keep the warning decals clean
and see to it that these are
replaced if damaged or missing.
WARNING DECALS
Please respect the information on the warning
decals !!