Instructions
1. Turn ignition off before making cable connections.
2. DO NOT touch red positive (+) clamp to black
negative (-) clamp.
3. Use in well ventilated area, shield eyes.
4. Prior to connection, make sure your iStart ON/OFF
switch is in the OFF position.
5. Connect red positive (+) clamp to positive (+) battery
terminal first. Connect black negative (-) clamp to a
non-moving metal part of the engine (ground).
If there is a beeping, reverse the clamp hook-ups.
The beeping should stop when properly connected.
6. Turn the ON/OFF power switch to the ON position
and start your vehicle. (Never turn your Portable Power
Pack on if there is a beeping sound.)
7. After starting vehicle, turn the iStart ON/OFF switch
to the OFF position.
8. Disconnect the black negative (-) clamp first, then
disconnect the red positive (+) clamp.
9. Always wrap jumper cables securely into place
after use.
10. After use, recharge your iStart.
11. Frequently check charge level of battery.
To operate the built-in work light, turn light switch on the
control panel to the ON position. Turn light off when not in
use to extend the life of the battery.
2
Get Started
Work Light Operation
The iStart is a versatile Portable Power Pack and 12 Volt DC power source that
can also be used with a DC to AC Inverter (not included) to provide 110 - 120
volt power to run small AC equipment and appliances.
Please read all operating instructions thoroughly before using.
To ensure maximum battery life, always charge your iStart at least every 30
days and after each use. Extreme fluctuations of either hot or cold outside
temperatures may require charging more often.
CAUTION: Read and Follow All Safety Rules and Operating Instructions Before Using
This Product.
PLEASE CHARGE YOUR iSTART PORTABLE POWER PACK IMMEDIATELY UPON REMOVING FROM THE
CARTON FOR AT LEAST 24 HOURS.
CAUTION
