Quick R02, Руководство по установке и использованию

Страница: 17 / 48

17
EN
RRC R02/12 - REV003A
OPERATION
Example of programming with translation:
Press key 3 on an RRC radio transmitter.
KEY PRESSED
ON THE TRANSMITTER
CORRESPONDENCE TO ENABLED RELAY
ON THE RECEIVER
1 (None)
2 (None)
3 1
4 2
Key 3 corresponds to relay 1, key 4 corresponds to relay 2.
Filter function (letter )
This function allows to select three different interference noise filtering modes within the function submenu
(see table).
The receiver is supplied set in AVERAGE mode.
Filter function submenu table
LOW: select when using in environments with only slight interference
AVERAGE: factory setting. Select when using in normal conditions
HIGH: select when using in environments with great interference
Once selected, letter remains on; keep the configuration button pressed until letter , or (depending
on the current setting saved in the receiver) flash at a constant frequency.
Release the configuration button. By subsequently quickly pressing and releasing the configuration button letter
, or (flashing at a constant frequency) can be selected. Once the configuration has been chosen among
those selectable, keep the configuration button pressed until the letter starts to flash at a fast rate, confirming that
it has been saved; next, the letter will appear and remain on. Release the programming button
After 10 seconds, if the configuration button is not pressed, it will go back to the letter being on constantly.
Erasing the memory (letter )
This function allows to erase from the receiver’s memory all transmitter IDs that have been saved using the or
programming function.
Once letter constantly on is selected, keep the configuration button pressed until letter stored flashing regu-
larly, passed 3 more seconds, it will start flashing at a faster rate. This confirms that it has been erased and then
the letter remains on. Release the programming button.
If the programming button is released before 5 seconds have passed, letter will go back to being on constantly
and the erasing procedure is cancelled.
Exiting the configuration menu ( simbol)
This function allows to exit from the configuration menu of the receiver.
Once the
symbol is selected, keep the configuration button pressed, the symbol will start flashing quickly
before shutting off. Release the configuration button. When exiting the configuration phase the ON/OFF LED will
start flashing again.
RADIO RECEIVER OPERATION
Reception of a command from the transmitter
When receiving a command from the RRC radio transmitter, the green ON/OFF LED will start flashing quickly.
The corresponding relay will activate and its activation is displayed by the red “relay activation” lighting up. Two
relays can be activated at the same time.
1
3
2
4
1
3
2
4
5 6
7 8
9 10
11 12
1
3
2
4