17
INSTALLATION
GB
GP2 SERIES GENIUS 500/1200 - REV001A
GB
WARNING:
before wiring up, be sure the electrical cables are not live.
BEFORE USING THE WINDLASS READ THESE INSTRUCTIONS CAREFULLY.
IF IN DOUBT, CONTACT YOUR NEAREST “QUICK
®
” DEALER.
WARNING:
the Quick
®
windlasses are designed to weigh the anchor. Do not use the equipment for other purposes.
Quick
®
shall not be held responsible for damage to equipment and/or personal injury, caused by a faulty use
of the equipment. The windlass is not designed for the loads that might occur in extreme weather conditions (storms).
WEIGHING THE ANCHOR Turn on the engine
.
Always deactivate the windlass when not in use. Check that there are
no swimmers nearby before dropping anchor. The splice between the rope and the chain must be tightly woven for the
rope to slide easily into the gypsy shape. For any problem or request, feel free to contact Quick
®
Technical Service. For
improved safety we recommend installing at least two anchor windlass controls in case one is accidentally damaged. We
recommend the use of the Quick
®
hydraulic-magnetic switch as the motor safety switch. Secure the chain with a further
device before starting the navigation. The contactor unit or reversing contactor unit must be installed in a point protected
from accidental water contact.
After completing the anchorage, secure the chain or rope to fixed points such as chain stop
-
per or bollard. To prevent accidental releases, the anchor must be secured. The windlass shall not be used as the only secu-
ring device. Isolate the windlass from the power system during navigation (switch the circuit breaker off) and lock the chain
securing it to a fixed point of the boat.
THE PACKAGE CONTAINS:
windlass - reversing contactor unit - base gasket - drill template - handle - bolts and screws (for assembly)
- user’s manual - conditions of warranty.
TOOLS REQUIRED FOR INSTALLATION:
drill and drill bits: Ø 9 mm (23/64") and Ø 11 mm (7/16”) - Ø 40 (1” 9/16) hollow mill; hexag-
onal wrenche: 13 mm.
“QUICK
®
”ACCESSORIES RECOMMENDED:
anchoring RL control board (mod. 800) - Waterproof hand helds R/C (mod. HRC 1002) -
Foot switch (mod. 900) - Hydraulic-magnetic circuit breaker - Anchor chain counter (mod. CHC 1102M and CHC1202M) - Radio control
RRC (mod. R02, P02, H02).
INSTALLATION REQUIREMENTS:
the windlass must be positioned with the gypsy aligned with the bow roller. Ensure that the
upper and lower surfaces of the deck are as parallel as possible. If this is not the case, compensate the difference appropriately (a lack
of parallelism could result in a loss of motor power). The deck thickness must be included among the figures listed in the table. In cases
of other thicknesses it is necessary to consult a Quick
®
retailer. There must be no obstacles under deck to the passage of cables, rope
and chain; lack of depth of the peak could cause jamming.
FITTING PROCEDURE:
when the ideal position has been established, drill four holes using the drilling template provided.Remove
excess material from the chain through hole, ensuring the free passage of the chain or rope. Position the windlass lowering it from
above deck and inserting the gasket between the deck and the base. Screw the stud bolts, using the short threaded end, onto the base.
Apply a medium grade locking product onto the thread. Fix the windlass by screwing the nuts onto the fixing studs. Connect the supply
cables from the windlass to the reversing contactor unit.
max 5 mm
(3/16”)
40 cm
(16”)
45°
Содержание GENIUS Series
Страница 2: ......