19
INSTALLATION
EN
BOW THRUSTER BTQ110-125 IT EN - REV002A
THE THRUSTER
To position the thruster in the tube, find the half-way point
and move to the value shown (
to the right or to the
left. See NOTE page 11
) in the table below so that the
propeller is positioned exactly half way along the internal
length of the tunnel.
• Use the flange to mark the centre of the holes on the tube.
• Fix the drilling template on the reference points, making
sure they are aligned with precision at the half-way point
of the tube.
N.B. All holes must be exactly aligned with the half-way
point of the tunnel, since tolerance between propeller and
tunnel is minimal.
• Take care that there are no resin residues in the
contact area between flange and tube; this could cause
misalignment. Any resin residues and any other hindrance to
correct contact must be removed by sandpaper.
• The thruster can be installed at any angle within 90° from
vertical.
• If the electric motor is positioned of necessity at an angle
of more than 30° from vertical, a special support must be
constructed.
1
0
2
3
4
5
6
7
8
9
10
1
0
2
3
4
1
0
2
3
4
BTQ110 50 mm
BTQ125 50 mm
• Insert one o-ring into the special seat inside the flange.
Содержание BTQ1102512
Страница 2: ......
