Quest Engineering Q Motion Series, Руководство пользователя

Страница: 6 / 12

QM 350i
User Manual
User Manual Q Motion Series
QM350i
4
Connections
Two Neutrik™ Speakon model NL-4
connectors are mounted in a removable panel
on the rear surface of the box.
The connector input is wired pin 1+ and pin 1-.
Pin 2 is not connected.
Take care when inserting the Speakon
connector twisting the connector until it
locks into place. Reverse the procedure to
disconnect.
Getting The Best From Your QS350i
Suitable Amplification
The QM350i is an 8 ohm enclosure and can
be connected in multiple parallel connections
to an amplifier channel that can operate at
speaker impedances of 4 ohms.
The QM350i is a mid power level high
efficiency system, so ultra high power is not
necessary to obtain high sound pressure
levels. The recommended power range per
amplifier channel is 350 - 500 watts RMS into
an 8
Ω
load or up to 1,000W RMS into a 4 ohm
load. An ideal partner to the QM350i are any
of the Quest QA range of amplifiers. Setting
the QA amplifier’s high pass filter at 35Hz is
recommended for full range applications. If
you are intending to add sub bass speakers,
the high pass filter can be set to 80Hz.
Recommended QM350i Amplifier Configuration
OUTPUT ASSIGNMENT
PIN 1+ :
PIN 1- :
S IGNA L
GROUND
LINK A
LINK B
INPUT A
INPU T B
Push To Reset
~ 220
240V 10A 50/60Hz
OUTPUT A
OUTPUT B
BRIDGE
PIN1:
PIN2:
PIN3: SIGNAL G ND
SIG NAL +
SIGNA L -
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
OFF 80Hz 110Hz
LOW PASS -A
26dB 32dB 1.4V
GAIN
STEREO PARALLEL BRIDGE
MODE
OFF 35Hz 80Hz
HIGH PASS -B
OFF 80Hz 110Hz
LOW PASS -B
ON OFF
LIMITER
LIFT GROUND
GROUND
DESIGNED BY QUEST ENGINEERING,AUSTRALIA
MODEL:
OFF 35Hz 80Hz
HIGH PASS -A
OFF 35Hz 80Hz
HIGH PASS -A
10
1
1 2
5
10
1
5
Reducing low frequency output will make more
amplifier power available for clean vocal reproduction
for full range sound, set the high pass filter to 35Hz