Quest Engineering DR4300, Начало работы

Страница: 7 / 64

DR4300 Version Number Getting Started With Your System
Getting Started with your System
7
3 Cable and connect your MD1400 storage enclosure(s) to the DR4300 (Optional).For more information
about cabling the DR4300 system with the MD1400 expansion shelf, see the DR Series System
Administrator’s Guide .
For redundant port configurations :
a Connect one end of each SAS cable to port 0 and port 1 on the DR Series system PERC controller.
b Connect the other end of each SAS cable to port 1 on each Enclosure Management Module (EMM)
on the MD1400 storage enclosure.
4 Power on your MD1400 storage enclosure before powering on your DR4300 system.
Configuring the DR4300 system
Follow these steps to configure network settings by using the Initial System Configuration wizard.
1 Log on to the DR Series system CLI using the local console KVM connection or an iDRAC connection.
The default user name is administrator and the default password is St0r@ge!
When you log onto the DR Series system for the first time, the Initial System Configuration Wizard window
is displayed for you to configure the network.
2 In the wizard, type yes , and press <Enter>.
3 Do one of the following:
a To select DHCP, type yes and press <Enter>.
b To select static IP addressing, type no and press <Enter>.
NOTE: To locate the primary EMM, see the Dell MD1400 Storage Enclosure’s Owner’s
Manual .
NOTE: Ensure that you power on the (optional) MD1400 storage enclosures before powering on the
DR4300 system.
NOTE: If you select static IP addressing, you will be prompted to enter the static IP address. Enter
the static IP address and press <Enter>. For static IP address, enter a subnet mask a default
gateway address, a DNS suffix and a primary DNS address. After configuring the primary DNS
address, an option to configure your secondary DNS address is displayed. Type yes or no as
appropriate and press <Enter>.
DR4300
PowerEdge RAID controller
MD1400
torage
nclosure
(optional)