quest
quest
1-866-933-7486
Quest Power Air Mover A3000
Installation, Operation and Maintenance Instructions
6
www.QuestProtect.com
7. Operating Instructions
The Quest Power Air Mover A3000 as packaged is ready to be put into service. Inspect the unit completely
for any shipping damage. Place the unit on the ground. Orient the unit so the desired air flow direction is the
same as the arrow indicator sticker in the FOCUS Technology corner on the interior of the unit. Plug the unit
into a grounded outlet and select the drying mode shown in Figure 6.
CAUTION: The Quest Power Air Mover A3000 consumes 2.5 Amps.
8. Operator Panel Features
8-1 Position Drying Selector Switch
The 3-position drying mode selector switch. This switch is used to select the Quest Power Air Mover A3000’s
mode of operation. The 3 modes of operation are OFF, LOW or HIGH.
OFF - The Quest Power Air Mover A3000 is not drying.
LOW - The Quest Power Air Mover A3000 is in “Normal” Drying mode. This mode provides rapid drying
and very quiet operation.
HIGH - The Quest Power Air Mover A3000 is in “Fast” drying mode. This mode provides the industries most
rapid drying while maintaining low noise operation.
9. Maintenance
WARNING: Disconnect the unit from power before servicing or cleaning. Replace the wire safety grill
after servicing or cleaning.
9.1 Servicing
Before each use inspect for damage, blocked inlet or outlet, or any excess buildup of foreign material.
When the Quest Power Air Mover A3000 is first turned on, check for excessive vibration. If the unit vibrates
excessively or if blade rubs on housing, turn off the unit immediately. Have a service technician inspect the
unit to locate the problem.
9.2 Cleaning
The housing is made of a durable and washable polyethylene. When cleaning, the use of solvents is NOT
recommended.
When washing inside the unit, disconnect the unit from its power source. Protect the 3-position switch with
a cloth. Clean inner barrel, grills and blade. Wipe down motor exterior with a damp cloth. If the motor gets
wet during cleaning, simply allow ample time for motor to dry out completely before restarting.
If you wash the Quest Power Air Mover A3000 and do not plan to use it within 24 hours, allow the fan to
drip dry for 10 minutes and then let run for 5 minutes.
