16
– 02|2016 – Subject to change.
Sportrex2 – Q6000A
Assembly
Tightening the backrest
The stable backrest is an important safety element. The straps underneath and behind the cabin
must always be tightened for a secure hold.
f
Tilt back the cabin and place it on its reverse side. This
makes the lower cabin frame accessible for assembly.
f
Tighten the two harnesses so that the backrest is
fixed.
f
Secure the straps using the buckles:
–
In each case, thread the end of the strap into the
buckle as shown.
–
It is essential to check that the two buckles are
secure.
f
Put the cabin into the upright position and open the
storage space cover.
f
Pull the harnesses that are tensioned around the
upper crossbar so that a clearance of approx. 2 cm
remains between the crossbar and the backrest.
Inserting the pennant
Danger!
The pennant must always be mounted in Trailer mode. Otherwise the very low
Sportrex2
is too easily not seen by other road users.
For safety reasons, we recommend putting the pennant into the pennant pouch so
that it is easily visible before every journey, including in Buggy or Walker mode.
f
Using the connecting piece, insert the pennant staff
into the extension rod.
f
Insert the extended pennant staff into the
pennant
pouch
on the outer left side.
f
Unroll the pennant so that it can fly clearly visible on
the pennant staff.
