UMTS/HSPA Module Series
UC20 Hardware Design
UC20_Hardware_Design Confidential / Released 27 / 82
The following figure shows the connection between the module and application processor.
USB_VBUS
USB_DP
USB_DM
AP_READY
VDD
USB_DP
USB_DM
GPIO
Module
Processor
RI
EINT
Power
Switch
GPIO
GND
GND
Figure 5: USB Sleep Application without Suspend Function
Supply power to USB_VBUS will wake up the module.
In sleep mode, module can still receive paging, SMS, voice call and TCP/UDP data from network, but the
UART port is not accessible. When the module enters into the sleep mode, the SLEEP_IND will output a
high logic level.
For more details about power saving mode, please refer to
document [8]
.
3.5.2. Airplane Mode
When module enters into the airplane mode, the RF function does not work, and all AT commands
correlative with RF function will be not accessible. This mode can be set with the following way.
Hardware:
The W_DISABLE# pin is pulled up by default, drive it to low level will let the module enter into airplane
mode.
Software:
Command
AT+CFUN
provides the choice of the functionality level <fun>=0, 1, 4.
AT+CFUN=0:
Minimum functionality mode, both USIM and RF function are disabled.
AT+CFUN=1:
Full functionality mode (by default).
AT+CFUN=4:
Airplane mode. RF function is disabled.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from