transmission requirements The user's manual for the host product must clearly indicate
the operating requirements and conditions that must be observed to ensure compliance
with current FCC RF exposure guidelines. To comply with FCC regulations limiting both
maximum RF ourput power and human exposure to RF radiation.
A label must be affixed to the outside of the host product product with the following
statement: This device contains FCC ID: YQD-QLM100
The final host/Module combinations may also need to be evaluated against the FCC Part
15B criteria for unintentional radiators in order to be properly authorizaed for operation as
a Part 15 digital device.
Information on test modes and additional testing requirements
Consider multi-transmission mode
in the host.
Additional testing, Part 15 Subpart B disclaimer
by FCC Part 15 Subpart B. The host be evaluated by the FCC Subpart B.
Single module procedures
The module has meet the requirements to satisfy the conditions.
Trace antenna designs
Please refer to the RF Link’s schematic diagram and refer to PCB Layout.
RF exposure considerations
The host device manufacturer should confirm that a separation distance of 20cm or more
should be maintained between the antenna of this host device and persons during the
host device operation.
Antennas
The device itself has antenna, customer can use the PIFA antenna with antenna gain
isn't greater than 3 dBi.
Lable and compliance information
If this certified module is installed inside the host device, then the outside
of the host must be labeledwith ''Contains FCC ID: FCC ID: YQD-QLM100 "
