Quebic Industries QueBQ, Инструкция по сборке

Страница: 9 / 11

together.CAUTION: Straps can flip open quickly, causing injury if not
tied together. Remove the dome and inner liners from the kamado
base. Remove the air inlet damper on the kamado base. Re-insert
the bolts and washers from the damper into their holes to form plugs.
Place kamado base on QueBQ. Locate your QueBQ where you are
going to use it. Be careful not to damage the coating when installing
the base. Carefully place the kamado base on top of the QueBQ
firebox with the kamado air inlet oriented to the chimney adapter
plate and 90 degrees from the front. The air inlet on the base will be
either right or left, aligning with the chimney. Adjust the base so the
kamado air inlet is aligned and the gaskets are well sealed. Look
through the upper chimney chamber to check alignment.
Rotate Hinge. The hinge strap needs to be rotated 90 degrees on
the base when it is installed so the hinge is in back. (Kamado Joes
have an index tab inside the hinge straps that orients the tab to holes
in the rim of the base and dome. The tab in the front of the kamado
base hinge strap needs to be sawn or ground off before installation
of the dome. The tab in the dome strap still orients the dome to the
front.)
Install dome on kamado. Carefully lower the dome into the hinge
strap with the thermometer in front. Align the dome on the base so
that the gaskets seal well, remove the stap ties, then tighten the
straps per the manufacturer's recommendations.
Install kamado braces. Bolt in the four support arms on as shown in
Figure 1 with (4) 1/4” x 3/4” SS Screws. Braces should be in contact
with the kamado body, but not stressed or tight.
Install logo. Congratulations! You may now christen your new
9