QUBINO ZMNHHD1, Руководство пользователя

Страница: 37 / 58

EN .
37
MINI DIMMER CALIBRATION
The Mini Dimmer has a calibration function to ensure correct operation in the 2-wire
configuration. The calibration determines the maximum and minimum dimming values for the
connected load to avoid that the load will take to much voltage from the module for its correct
operation.
The calibration will perform automatically once the module is connected to the power for the
first time. If the module will not be included in any gateway the calibration will perform again
after each power cycle. During the calibration procedure the blue LED will be ON. If the
calibration will not perform correctly or any error will occur the blue LED will start blinking. Once
the module is included and a power cycle is done the calibration will not start. To force the
calibration (in case of load change) or trigger it after each power cycle even if the module is
included you need to set the correct value in parameter 71 Calibration Trigger. With parameter
72
you can also check the calibration status in case the module is already mounted and you can’t
see the LED status. For more information about those parameters please see chapter
Configuration parameters on page 40.
ⓘ
NOTE: when changing the connected load is strongly recommanded to force the calibration
to ensure correct operation.
OPERATION
The Mini Dimmer can be switch ON/OFF with:
•
Pressing the switch connected to I1
•
Sending a Basic Set command
•
Sending a Switch Binary Set command
•
Sending a Switch Multilevel Set command (only if in dimmer mode)
•
Sending a Start/Stop Level Change command (only if in dimmer mode)
ⓘ
NOTE: dimmer or switch mode can be set with parameter 5. Please refer to chapter
Configuration parameters for more information.
ⓘ
NOTE: In Dimmer mode the Basic Set will react as Switch Multilevel Set and In Switch mode
the Basic Set command will react like Switch Binary Set.