QubicaAMF XLi Pinspotter Motor and Gearbox Manual
400-088-038
5
Revision F
11.
Remove the table motor from the gearbox.
12.
Clean all surfaces of the table motor and gearbox with a cloth dampened with a water-based cleaner.
13.
Check the gearbox for any signs of oil leakage. Repair as needed.
14.
Check for loose bolts (6) holding the gearbox flange to the gearbox housing. Tighten as needed.
15.
Check the table motor key for excessive wear. 50 Hz gearboxes with serial numbers before 110912-1
and 60 Hz before 102812-1 also have an anti-fretting sleeve (088-004-518) that should be checked.
Replace as needed.
16.
Drain and fill the oil in the gearbox in accordance with Section 1.3.4, Changing the Gearbox Oil.
17.
Service the table motor, brake, and encoder in accordance with Section 2.3.1, Servicing the Front End
Motor, Brake, and Encoder.
18.
Apply a liberal amount of anti-seize compound to the table motor shaft and to the bore of the input
shaft of the gearbox.
19.
Attach the table motor to the gearbox, aligning the key with the keyway. Note the orientation of the
sweep motor to the gearbox. The capacitor and electrical box must be toward the front of the gearbox
(sight glass side).
20.
Install and tighten the three bolts and nuts securing the table motor to the gearbox.
21.
Rotate the gearbox output shaft by cranking the motor shaft 20 revolutions to develop a new wear
pattern on the gears.
22.
Wipe the old grease from the table drive shaft splines.
23.
Apply a liberal amount of anti-seize compound to the splines of the table drive shaft and the bore of
the output shaft of the gearbox.
24.
Install the table motor and gearbox assembly by aligning the splines of the table gearbox and the table
drive shaft. Push the table gearbox onto the table drive shaft.
25.
Install and tighten the three bolts and nuts securing the table gearbox assembly to the crossbeam.
26.
Install the spring hangers and springs to the spot and re-spot arm link assemblies.
27.
Connect the table brake and encoder cables to the wire harness in the wire-way. The cables should
pass thru the grommet.
28.
Install the crossbeam cover.
29.
Crank the table so that the block of wood can be removed.
30.
Connect the power cord to the table motor.
31.
Restore power to the pinspotter.
32.
Run the table thru one complete cycle.
33.
Run the sweep and table to the home position.
34.
Cycle the pinspotter and observe for correct operation.
