PiXtend
Construction manual:
PiXtend V1.3 Full
Kit Assembly
Some of the resistors already can be differentiated by the different counts. But the colour
code or resistor value (with Ω- meter) should be checked still.
It turned out as good to first place all resistors of one type and then solder the first pins.
The resistors can be placed and fixed in the same position (Figure 29).
T some places it is better to place the resistor and fix it directly by a soldering joint. In
Figure 30 is shown a place like that. If all four resistors would be placed in the row first, so
it would be hard to solder the resistors in the middle.
www.pixtend.de
Copyright by Qube Solutions UG (limited liability)
35 / 75
Figure 29: Fixing of the resistors
