© Quatro Air Technologies| MAY 2019 | All rights reserved |
iVAC Premium Series Operation and Maintenence Manual
Page 21
Filter Service and Replacement
4.
Hold for 10+ seconds, when panel is beeping continuously, release buttons
5.
You are now in RESET MENU, in this condition, System ON Led is flashing QUICKLY
6.
Press SPEED DN (2 Times) until
Service Filter(s)
LED is flashing.
7.
Press and HOLD POWER button
while
Service Filter(s)
LED is flashing and unit is beeping continuously.
8.
Release when LED stops flashing and stops beeping.
Filter Cleaning System (FCS) Motor Replacement
The FCS motor is considered a wear item and has a service life. The FCS motor should be replaced when L4 is ON
SOLID. L4 illuminates at the end of the FCS motor predicted service life. The FCS motor may continue to run after L4 has
illuminated but it is best to have a replacement on hand.
(For steps 1 through 4, refer to photos in
"Main Filter Cleaning and Replacement" on page 18
1.
Unplug power cord and open filter access door(s).
2.
Unplug FCS electrical quick disconnect.
3.
Remove the dust tray expose the wingnuts that secure the Main Filter Hold Down bracket.
4.
Remove the main filter support bracket by removing the wingnuts.
5.
Remove the 7/16 locking nuts holding the FCS motor to the main filter support bracket.
6.
Install the new FCS motor to the main filter support bracket using the 7/16 locking nuts.
7.
Re-install the main filter bracket
using the 2
NEW
plastic wingnuts provided with the replacement FCS motor.
8.
Re-connect FCS electrical quick disconnect and close motor access door(s).
9. Plug in power cord and
Reset FCS Alert.
This MUST be done
EVEN IF L4 IS NOT ILLUMINATED
or the FCS
replacement alert will not function correctly. Follow the instructions below.
•
Ensure filter access door is closed.
•
Plug power back to the unit.
•
Press and hold SPEED UP and DN simultaneously until unit beeps.
•
Hold for 10+ seconds, when panel is beeping continuously, release buttons.
•
You are now in RESET MENU, in this condition, System ON Led is flashing QUICKLY.
•
Press SPEED DN (3 Times) until
Auto-Cleaning Filter
LED is flashing.
•
Press and HOLD POWER button while
Auto-Cleaning Filter
LED is flashing and unit is beeping continuously.
•
Release, when LED stops flashing and stops beeping.
