QUATRO
Air Technologies Inc.
----------------------------------------------------------------
Engineers Of Clean Air
----------------------------------------------------------------
30 Hymus Blvd., Pte-Claire, Quebec, Canada H9R 1C9 Tel.:(514)630-4444 Fax:(514)630-4454
www.quatroair.com
2
OPERATING INSTRUCTIONS
a) Connect 1-½” dia. hose to inlet on top of unit.
b) Connect other end to your 1.5” dia connection
c) Plug-in the power cord to both Dust Collector / Purifier Control Panel and 115-volt wall outlet.
d) Start unit by pressing Hand-Switch or Foot-Pedal.
EQUIPMENT MAINTENANCE (in order from top to bottom)
Filter Bags:
When you notice a significant drop in suction, it is time to change the filter bag. Do not try to clean filter
bag as this will result in tear. To replace Filter Bag, unhinge top cap of unit and remove cap. Slide the bag inlet off the
inlet pipe and replace.
Perforated Metal Grille:
MUST be placed between the filter bag and the filter below it. When filter fills with debris,
Perforated grille prevent debris in filter bag from blocking the filter below it.
Odor Filter (For Dust & Odor Applications):
Ensure this is always placed on top of HEPA filter.
HEPA Filer:
This is the most efficient filter and must be installed LAST, and just above the motor section.
Box Filter:
All-in-one box filter for lower debris, higher odor applications (consult with factory)
WARNING: DO NOT OPERATE UNIT UNLESS FILTER IS IN PLACE, AS MOTOR MAY BURN-OUT.
BLOWER MAINTENANCE
Refer to following figure when performing this procedure.
Note the orientation of the bracket.
CAUTION:
ALLOW MOTOR(S) TO COOL FOR 45 MINUTES BEFORE SERVICING.
Filter Bag Perf Spacer Odor Filter HEPA Filter Box Filter
A . Retaining nuts (4X)
B . Motor-to-bracket, mounting screws (4x)
C . Black wire terminal
D
. Green wire terminal
E
. White wire terminal
F . Motor retaining bracket
1. Unplug power cord and open motor access panel
2. Disconnect wires (C, D,E), cut zip ties
3. Remove the retaining nuts (A) and lock washer holding
the motor assemblies
4. Remove the motor retaining bracket (F) from the old
motor by removing the 4 mounting screws (B)
5. Install the bracket on the new motor. See the
installations pictures below.
