Quatreau SmartTap, Руководство пользователя

Страница: 7 / 14

7
————————————————————
5.1
TAP FUNCTIONS:
SPARKLING FILTERED WATER
CHANGING THE CO2 CANISTER
When the sparkling water tastes flat it is
necessary to change the gas canister.
The integral CO2 gas canister is sited on
the left hand side at the front of the unit
(see diagram opposite).
Please follow the instructions below to
ensure your CO2 canister is correctly
installed:
1 To remove a canister unscrew in an
anticlockwise direction.
2 Locate the thread on the regulator
where the gas canister will connect.
3 Carefully present the canister ensuring
the canister is supported.
4 Rotate the canister in a clockwise
direction being careful not to cross
thread the regulator.
5 Rotate until you hear a hissing sound.
This is the gas being released from
the canister. It is important to keep
screwing until you can no longer hear
this hissing.
6 When the canister cannot be turned
further it is safely connected. Do not
turn the canister any further as this will
damage the regulator.
7 Press the glass icon button and run off
an amount of sparkling water to
re-calibrate the system.
Note :
While removing a canister it is important to
support its weight to avoid the canister
dropping onto the floor.
When attaching a new gas cannister
hand tighten the gas cylinder firmly but
and do not over tighten. Check by
listening that gas is not escaping.
The regulator has an internal opaque
white coloured seal that should stay firmly
in place. Older models have a black
o-ring. If these are removed or fall out the
gas will escape.
The regulators have two cross head
screws attaching the regulator to the front
panel. These are tightened during
manufacture and shuold be checked
periodically at service intervals, if they
come loose gas will escape.