you choose is suitable and that you can
reach the controls without needing to
stretch.
We typically set back approximately
50mm from the back edge of the sink.
Your kitchen design will of course dictate
whether this is possible. Before you start
cutting ensure that you have set up a jig
or a template device to prevent the drill
bit moving when you start the cut.
Once the hole is prepared, remove any
rough edges or bits of wood and place
the tap carefully into the hole ensuring
that the comms cable is dropped into the
hole first to prevent damage.
Using the washer and fixing bracket
provided, you can now fix the tap in
place underneath the work surface.
Take care to locate the comms cable into
the groove behind the tap base then slide
the washer up over the base followed by
the fixing bracket. This will screw onto the
thread on the tap base.
Ensure that the comms cable is recessed
into the cable channel to avoid
damaging it as you spin the bracket
clockwise until it is almost at the top of the
thread.
At each side of the fixing bracket you will
see a threaded hole. Using the two bolts
provided thread up into these holes until
tight against the washer above. With a
flat head screw driver, tighten each one
gently.
Now position the tap so that the control
panel faces forward towards the user
position (180 degrees to the sink). Now you
can tighten the nuts until you have a firm
fixing on both sides.
The comms cable hangs down and will
connect into the QT553-B unit when it is
installed. It’s essential that the QT553-B
is located close to this cable without
causing it to stretch
————————————————————
QUATREAU TOUCH
CONNNECTING YOUR TAP
————————————————————
Once the faucet is in position you are now
ready to connect the tap to the QT553-B.
1. Remove the end cap from thefront
manifold stem. If unsure how to
remove this fittingplease refer to
https://www.johnguest.com/speedfit/
product/cts-jg-twist-lock-fittings/end-
cap/ or search online for John Guest
push fit end cap removal.
2. You will find 2 lengths of silicon pipe in
the fitting kit, one pre asembled with
a VenturiT piece. The longer section
connects to the front outlet on top
of the boiler control unit whilst the
shortest pipe fits onto the underside
of the tap base (on the right hand
connecting stem). Fix in place using
the spring loaded clips included in
the fitting kit.
3. The rear manifold stem is the mains
hot and cold water. This connects
to the left hand stem of the tap as
you look at it inside the cupboard.
This is one continuous run from boiler
control unit to the tap. It doesn’t need
a drain off device.
4. The boiling, chilled and sparkling
supply must have the Venturi T
included (see diagram). The Venturi T
requires a Type AA drain connection
in accordance with your local
plumbing code.
INSTALL ATION