3. OS/2 Installation
In order to use the QSP-100 Client Driver for OS/2, the system must be configured as follows:
1. The system must be running OS/2 2.1 or later.
2. OS/2 PCMCIA Card and Socket Services support must be installed. If PCMCIA
support was not selected when OS/2 was installed, it can be added using the Selective
Install facility in the System Setup folder. On OS/2 2.1 and 2.11, Socket Services
must be added separately. The necessary files can be found on Compuserve in the
OS2SUPPORT forum and may be available elsewhere. These files are not available
from Quatech Inc.
3. Quatech's OS/2 serial port device driver, "QCOM" version 2.01 or later, must be
installed. The QSP-100 will not operate with the standard OS/2 serial port device
drivers. Quatech Inc. can not guarantee the operation of the QSP-100 with any other
third party device drivers for OS/2.
4. There must be at least 32 bytes of available I/O space and 1 available IRQ.
After the system has been configured to the above specifications, the QSP-100 Client Driver may
be installed with the following procedure:
1. Copy the QSP100.SYS client driver file from the distribution Quatech COM CD to
any convenient directory on the hard disk.
2. Open the CONFIG.SYS file using any ASCII text editor.
3. Add the following line to the CONFIG.SYS file:
DEVICE =
drive
:\
path
\QSP100.SYS
options
where
options
are the QSP-100 OS/2 Client
Driver command line options discussed in the following sections.
4. Save the CONFIG.SYS file, exit the text editor, shutdown the system, and reboot to
activate the changes.
QSP-100 Users Manual
17
Содержание QSP-100
Страница 6: ...QSP 100 Users Manual 3 ...
Страница 27: ...5 During the installation process it may be required to supply the computer with the QSP 100 Users Manual 24 ...
Страница 38: ...This Page Left Blank Intentionally QSP 100 Users Manual 35 ...
Страница 40: ...QSP 100 User s Manual Version 1 42 March 2004 Part No 940 0102 142 QSP 100 Users Manual 37 ...